Your water heater is one of the most used and higher priced appliances in your home, and consumes a large involving your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving on your home heating as well as costs.
Regular flushing of one’s water heater has become single most important step you consider to prolong its service life in addition, it save energy. For time, sediments amass in the bottom of your hot water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. This is not only destructive to the tank, but highly inefficient and will significantly raise your heating costs.
In most regions of the country, the average water heater lasts 3-5 years. Regularly flushing your hot water heater can double daily life of your hot water heater from 3-5 to 7-10 years. Something else costs of replacement running from $700 to over $1200 in some cases, getting the most from your heater is a must in today’s economic condition. In addition, regular flushing makes your hot water heater run more efficiently and can cut heating costs in half. Depending on the volume of warm water your home uses, that can mean a savings of $20 to over $50 a week.
To drain your water heater, on the internet should set the thermostat to pilot (if it is often a gas water heater) or turn the circuit breaker off (if it is actually electric heater). Failure to do so could result in overheating and severe damage to the actual heater. Next, close the water supply valve located on the water inlet line going into your water heater. After backing up connect a garden hose to the drain valve located in the bottoom of the heater tank. Open the drain and allow it working out until all of the water has emptied from the unit. Then close the drain. Open the water supply valve and refill the heater tank. You should also open a hot water faucet somewhere at home and stand there and watch it run for several minutes until the flows out perfectly. This will allow air to vent off of the heater and the hot water lines. Finally, you can turn the thermostat to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).
Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your property to filter or condition the water so it is less corrosive to your plumbing system, particularly in areas which have hard stream. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in your area to discuss options and merchandise to be fitting.
Abacus Plumbing, Air Conditioning & Electrical
The Woodlands, TX